??!

19 questions from our users

Joanne

Joanneasked

BDW127X-F (Stainless Steel)

Hi how do I move the shelves around and the water thing?



No answers
Leanne S.

Leanne S.asked

BDW127X-F (Stainless Steel)

Hi my Bellini tap light is flashing, how do I fix this please

1 answer
Ross M.
Ross M.

It's a red tap symbol. The dish washer is great but water overflow protection is supply pipe seems to fail often. It's covered under warranty so suggest you contact warranty people. Leave a message. They usually reply quickly.
Good luck.

Cindy B.

Cindy B.asked

BDW127X-F (Stainless Steel)

Just brought today set up it up and turned the power button on the heavy and normal light is flashing but won't even go onto a wash cycle

1 answer
Mark F.
Mark F.

Hi Cindy, Is your model BDW6WP-F or BDW6XP-F? Heavy and normal light is flashing means there is overflow/leakage of your machine. Please check.



Joe M.

Joe M.asked

BDW127X-F (Stainless Steel)

I'm getting the water supply error and the dishrwasher won't fill. I've checked the filter inlet valve, removed and cleaned the red filter. The hose lines aren't kinked.

3 answers
Josh
Josh

Mine did that and It was the hose, I got mine replaced not even a month ago. Fella that fixed said he does bellini hoses all the time. I tried through the warranty and waited a month without them contacting me so I just got it fixed.

Joe M.
Joe M.

I'm afraid this is going to the recycling centre as junk.

Yasemin S.
Yasemin S.

Hi josh we have the same
Problem are you from Melbourne if so would you be able to forward details for repairment please



Craig G

Craig Gasked

BDW127X-F (Stainless Steel)

The machine is telling me it has abnormal heating, how do l repair this.

1 answer
Mark F.
Mark F.

Check the wire of heating element, if there is no problem, then it is suggested to replaced a new heating element.

Debbie S.

Debbie S.asked

BDW127X-F (Stainless Steel)

Dishwasher will only wash on cold, can not move cycle to hot wash

1 answer
Mark F.
Mark F.

It can be connected to hot water upto 60°.

Colin W.

Colin W.asked

BDW127X-F (Stainless Steel)

It won't pump out

1 answer
Mark F.
Mark F.

Check if the drain pump broken, check if the sump has been blocked by the remains, then finally check if the drain hose is bending or not.

ange

angeasked

BDW127X-F (Stainless Steel)

where can I purchase an aqua stop for my bellini dishwasher

2 answers
Mark F.
Mark F.

Hi Ange, inlet hose with aqua stop can be purchased from the ebay as it's a universal part for dishwasher. You can use other aqua stop brands as well. And then ask the seller to help you on how to replace a faulty one. And if your dishwasher is in warranty period, kindly ask for a service, Thanks

ange
ange

Thank you lucky I found my receipt and it was still under warrenty. Price for part in NZ $160

Ian P.

Ian P.asked

BDW127X-F (Stainless Steel)

Water light is on and water wont enter. I am told this is a water inlet valve problem most likely and need to source one . Where can I get one and what do they cost ? BDW127X-F series Ian 0412 223715 or [email protected]

2 answers
Mark F.
Mark F.

Hi Ian, Water inlet malfunction, the problems would happen on the inlet hose, inlet valve, pressure switch. Is your dishwasher with an aqua stop inlet hose? If yes and got a faulty on that part, you may have to check and buy a new inlet hose with aqua stop.

Ian P.
Ian P.

Hi Mark, thanks of that, Im not sure. I will need to pull the back off again.

Lena S

Lena Sasked

BDW127X-F (Stainless Steel)

A yellow and green wire has come of in back of panel after we discovered no power supply. Any ideas?

2 answers
Daz
Daz

Yellow/green is the earth wire, reconnect and try again.
If you are not an electrician do not mess with electricity; it can kill you.

Ben
Ben

You need to get the dishwasher checked by an electrician, a fault with the earth connection can be very dangerous. The washer could work perfectly fine but be a trap ready to electrocute someone who touches the wrong part.

Unhappy

Unhappyasked

BDW127X-F (Stainless Steel)

Should your product really be crapping themselves and playing up all the time ??Really hope your chasing up these issues and acting accordingly, water sign coming on all the time and beeping and turn on and off all the bloody time !!! Look forward to your response

1 answer
mark j.
mark j.

These machines are a horrible waste of money better off throwing it in the bin

Treez

Treezasked

BDW127X-F (Stainless Steel)

Bellini dishwasher gone through 3 diff faults in first few days of purchase. Any ideas? Before we plan to get a refund at Burnings.

1 answer
phatt dave
phatt dave

Return it to Bunnings for full Refund, and look for a known brand name on special, you may have to add a bit more to your budget but it will be worth it...cheers

Phillip B

Phillip Basked

BDW127X-F (Stainless Steel)

Front door latch has stayed down in a release position. Tried running a cycle whilst leaning up against the door to see if it would reset itself but no luck. Any ideas?

2 answers
Zoe
Zoe

Mine has just done the same thing!! How did you get yours fixed please?

Steve M.
Steve M.

I took the front panel off and then the latch itself. You can reset the spring by pushing the latch mechanism with the end of a spoon.

Shaun R

Shaun Rasked

BDW127X-F (Stainless Steel)

My dishwasher works fine but every now and then it will start beeping and no water sign will flash. I have made sure no other appliances that uses water is running at the same time so it always have water available, but it still does that every now and then, any ideas?

3 answers
IanCP
IanCP

I think it may be on the way out. We are on our third warranty replacement Bellini dishwasher and the first one did that. The warranty people attributed it to a sensor error which eventually resulted in a circuit board failure and the complete failure of the machine. Obviously yours may differ, but the symptoms are very similar.

lina1404
lina1404

Im gonna check my drainage. It could be just the plumbing blocking and unblocking. I just went through everything on line and found that its most likely that in my case.

Shaun R
Shaun R

I found by keeping the strainers clean all the time eliminated this problem, what still sometimes happen it will stop before the rinse cycle is completed but that does not happen very often.

Dan O

Dan Oasked

BDW127X-F (Stainless Steel)

2 & 7 Lights are flashing after a power outage. Manual advises overflow/leakage - and to call service - machine is 2 months out of warranty.

Seems to be a common issue in this thread - can anyone advise how it has been fixed? Unit is neither leaking for overflowing.

6 answers
IanCP
IanCP

Hi Dan,

I am just going through this issue myself, albeit with a machine which is still under warranty. A local firm here carries out warranty repairs for Bellini, and they arrived with a new circuit board and a new water pump which had been sent through by Bellini based purely on my explanation. That, and the frequency of reports of this nature, suggests to me that it is a known issue.

Unfortunately, however, it didn't fix the problem (Like you there was no leak or overflow)

I would seriously question whether this equipment is fit for purpose. It almost seems as if there is a design or manufacturing fault which should arguably have been cause for a recall given the frequency it arises.

However......I don't hold out much hope for you. Their service so far has been woefully slow and I sense no genuine commitment to resolving my complaint. Given that the machine is out of warranty, I am afraid my suggestion is to cut your losses, throw the thing on the recycling pile and get a better brand. To spend money repairing this seems false economy to me.

Sorry I couldn't be more positive.

Dan O
Dan O

I completely removed all water from the device, lots of paper towel, sat it disconnected overnight, reconnected water and power and the issue resolved itself. Lucky I guess :)

Grechey
Grechey

I have recently had the same problem . My problem occurred when my sink drain blocked and the dishwasher was draining at the same time. What actually happens is the drain pump on the dishwasher can't pump water out and the outlet hose pressurises causing a small leak into the catch pan under the dishwasher. In this catch pan is a sensor which senses water. To clear this error you have to tilt dishwasher on a 45 degree angle to the right which drains this water out of the catch pan ( you may need a rag to clean floor as it will create a bit of a puddle on your kitchen floor. Put dishwasher back to its upright position, turn on/off button back on and error should clear.

McDougall

McDougallasked

BDW127X-F (Stainless Steel)

Hi I have a problem with the water not pumping out, any help?

1 answer
Karway
Karway

We found that turning the machine off and on again, then restarting the cycle. If that doesn't work then change to a quick wash or rinse cycle to clear the dishwasher. Then operate as normal next cycle.

Stephanie Wiki

Stephanie Wikiasked

BDW127X-F (Stainless Steel)

Hello. I purchased this dishwasher and it is not draining. I have had a plumber out and have been told it's a dishwasher fault. How long is the warranty please?

1 answer
T.B
T.B

2 years

tanya67

tanya67asked

BDW127X-F (Stainless Steel)

Tried to turn dishwasher on it goes on for 5 mins and then turns off water supply won't come on what can i do to fix it?

1 answer
Brad
Brad

Try turning itvoff at the wall. Unplug it preferably for an hour. If it doesn't run youll havecto contact the manufacturer. Goodcluck there.

meiketies1

meiketies1asked

BDW127X-F (Stainless Steel)

what to do when the dishwasher doesn't pump the water out again?

1 answer
CatMad
CatMad

How long have you had the dishwasher?
It is probably the pressure guage that connects to the tap. You can buy the whole pipe and replace. I chose to buy a new one as mine was 4 years old.

See all Bellini BDW127 Series questions

Get an answer from our members

ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.