??!

68 questions from our users

Suzanne H.

Suzanne H.asked

DSF6106W (White)

My dishwasher DSF6106W keeps flashing the end of cycle button...have switched off then on again...NOTHING still the same, tried to reset by pressing the 2 buttons together still nothing. there must be a sequence....cam somebody please get back to ma asap. Thankyou! Havent a
had a problem with this dishwasher until now been very happy otherwise.



No answers
Basma

Basmaasked

DSF6106W (White)

My Dishlex DSF6106W dishwasher takes 2.5 to finish when I’ve turned the knob on 50 ECO how can I reduce the washing time. Thanks

No answers
Sean C.

Sean C.asked

DSF6106

Not heating water up

No answers
Sean C.

Sean C.asked

DSF6106

Not heating water up

1 answer
leebrown
leebrown

Ours too. Two weeks old



Jodie

Jodieasked

DSF6106X (Stainless Steel)

My dishwasher won’t start. The bottom light on the right hand side flashes 12 times at a time.

1 answer
Dishlex
ELECTROLUX ..Dishlex

Hi Jodie,
Tania from Electrolux here.
We are sorry to hear you are experiencing problems with your Dishlex dishwasher.
If you wish to discuss this further please feel free to contact me at [email protected] attention Tania. Please be sure to list the ticket number 1262240 in the subject line
Thanks, Tania

Latiffa

Latiffaasked

DSF6106W (White)

My dishlex is flashing at the end cycle and will not do anything else. What to do? I do not have a manual.

No answers
DeborahMarie B.

DeborahMarie B.asked

DSF6106X (Stainless Steel)

Have only just bought and installed d/washer. It does not seem to be turning off, or for a really really really long time. It has been on the 14 minute cycle now for around 140 minutes??? What the??



No answers
Zita S.

Zita S.asked

DSF6106W (White)

My Dishlex DSF6106W (white) how do you put it on half wash and does the half load indicator light up when its on pls.

2 answers
DeborahMarie B.
DeborahMarie B.

Press both buttons at once and hold down for around three seconds

Zita S.
Zita S.

thank you Deborah, we've worked it out.

Zita S.

Zita S.asked

DSF6106W (White)

when put on half load, is there a red light on and how do you set it to half load pls

No answers
Tony D

Tony Dasked

DSF6106X (Stainless Steel)

Why is there water left in the bottom and won’t drain after a cycle has finished, how does the water escape and how do you rectify this

No answers
Linda

Lindaasked

DSF6106X (Stainless Steel)

It doesn’t finish the cycle properly & leaves water. When I try another cycle the water is pumped out first so no blockage. Have now tried all the cycles & they all end with the arrow light flashing 2 times intermittently. It’s only a couple months old

1 answer
Robbie
Robbie

Hey Linda, how'd you go with this? I've got the same problem :(

mat

matasked

DSF6106

our dishlex dsf6106 washed the first time great but every time after that it is leaving things dirty and not clean at all, is there something to look for to fix the problem? filter in the bottom is clean.

No answers
Helen V.

Helen V.asked

DSF6106X (Stainless Steel)

No lights and of course no go

No answers
Anne

Anneasked

DSF6106X (Stainless Steel)

Can’t connect tap fitting

No answers
william K.

william K.asked

DSF6106W (White)

How to change drain hose on Dishlex DSF6106W

No answers
william K.

william K.asked

DSF6106W (White)

how to replace drain hose on Dishlex DSF6106W

No answers
Daniel H.

Daniel H.asked

DSF6106X (Stainless Steel)

What is the little piece of plastic for, on the top shelf, in the front, left corner?

No answers
Sean R.

Sean R.asked

DSF6106

Dishlex DSF6105X has a fault. Tried the following process several times for the same result: 1. Reset control panel 2. Start a cycle. Machine sounds like it's filling...engine is whirring. 3. Two minutes later it stops. 4. Arrow indicator flashes 15 times, then pause. 15 times, then pause etc...Any ideas?

No answers
Rhys Holleran

Rhys Holleranasked

DSF6106X (Stainless Steel)

A rat has chewed a hole in my outlet hose .. I can’t work out how to remove the hose from the bottom of the dishwasher.any ideas

1 answer
Kathryn H.
Kathryn H.

We would also like to know this, for the same reason...Last night my partner loosened a side panel and squeezed his hand in there to remove the old hose but now I have to get another hose as the one I bought has a fitting too large for this machine. I thought they were all they same.

GeeBee

GeeBeeasked

DSF6106W (White)

My Dishlex DSF6106W is just over 2 years old, so out of warranty. Today it leaked and didn’t finish its cycle. I removed the filter and it was clear, but there’s still about 5cm of water sitting there in the draining hole. I phoned the service number and they can only send a service person in a week’s time at a cost of $145. I’m a pensioner and can’t afford this. Does anyone have any tips about what I can do? I can’t get at the back of the machine to check the hose.
Any ideas?
Thanks

No answers
Page 1 of 4

Get an answer from our members and Dishlex representatives

ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.