??!

13 questions from our users

Melanie R

Melanie Rasked

WSF6606W (White)

WSF6606X



We have just purchased a WSF6608 Dishwasher. We have not been able to use it as every time we’d turn it on it comes up with the F5 error. Very disappointed. This is despite checking every hose and making sure of everything it says in the manual. Help please?

1 answer
Westinghouse
ELECTROLUX ..Westinghouse

Hi Melanie R,
Marina from Electrolux here.
If the issue you have raised is still not resolved at this time, can you please email me your contact details at [email protected] attention Marina.
We would really like to try to assist you.
Thanks,
Marina

Jason

Jasonasked

WSF6606W (White)

My dishwasher has glass in it - how do I clean it out?

No answers
Vanessa L

Vanessa Lasked

WSF6606W (White)

i have F5 error code coming up on my machine what does this mean?



2 answers
Ronikins
Ronikins

F5 is a water supply problem. Check the tap is on or if there is an inlet filter after the tap that is blocked.

Nick
Nick

Hi Vanessa, Did you get this sorted? I have the same prob, wouldn't start a cycle, then i repositioned the inlet hose and it worked again for about 3 washes, but then again F5, plenty of pressure. Rang Electrolux, they suggested I contact the service centre.

Joyce L

Joyce Lasked

WSF6606W (White)

H23 error code on my 606x dishwasher . Not in manual. How do we fix this error?

No answers
Minyaka

Minyakaasked

WSF6606W (White)

Can I disconnect the heating elements and just have the dishwasher use the hot water......my reason is ...the dishwasher is on a houseboat and we run our power with an inverter or generator...but once it gets to drying dishes the power fails.
Our previous dishwasher was a dishlex and the electrician disconnected the heating element and it worked fine for 16 years.



1 answer
XYZed
XYZed

Hi Minyaka . You could try to remove the wiring to the heater element (the grey box). Though my guess is it may throw an error message about a fault with the heater element then - probably F6 (faulty heater sensor)

Cookie72

Cookie72asked

WSF6606W (White)

Where can I get a full set of water pipes (part numbers) for this dishwater> A bloody mouse got into the machine and chewed holes in them. The machine is just over a week old.

No answers
Brett

Brettasked

WSF6606W (White)

Hi, now have an F9 error soon after starting cycle to eco wash. no previous issues with machine. Have remove filter and cleaned it and also cleaned small holes in bottom of machine where filter sits. Also checked inlet filter but all good. Someone mentioned an outlet hose filter may need unblocking ? Any help much appreciated . Thx

1 answer
Alto L.
Alto L.

Handy Husband fixed it, our error F9 fixed by, Googling (Google) - Westinghouse dishwasher model wsf6608x flow control valve, under images open the pic diagram 942001222 00 - Wholesale Appliance Supplies, spare part 123 cost $9.90 picked up part from Northside Appliance Spares & Repairs Pty Ltd, 189 Robinson Rd, East Geebung, QLD, [email protected]
(Facing the dishwasher take off the left side panel and replace 123 part)

Dee

Deeasked

WSF6606W (White)

I am having problems with dishes not drying. Any help?

2 answers
Zai
Zai

Hi Dee which cycle are you using? some of the short/fast cycles don't run the drying heater, the manual shows which ones.

Dee
Dee

Yes keep switching btwn the 2 that dry...tried increasing rinse aid, everything the manual suggests. Have someone coming to check it out next week. Thank you for your reply.

Ilana G

Ilana Gasked

WSF6606W (White)

Dishwasher shows 1.5p and progresses through to 9.5p. Tried turning the power off. Can't grt it to complete a cycle. We cleaned out the drain. If we start a cycle it goes to 1 minute and then finishes. Any suggestions?

1 answer
Rocket
Rocket

Hi. I just had the same problem. It initially showed F5 then that sequence 1.5P-9.5P. I cleaned the inlet water filter then let the dishwasher go through the same sequence. It then went back to normal. The P sequence must be a diagnostic reset perhaps? Good luck I hope you’re back on track. I bought an extended warranty, still got 4 years to go.

Lyn

Lynasked

WSF6606W (White)

Just brought this dishwasher two days ago the door does not line up on both sides. Any ideas?

1 answer
Westinghouse
ELECTROLUX ..Westinghouse

Hi Lyn,
Leslie from Electrolux here.
We would appreciate the opportunity to discuss the concerns you have raised about the Westinghouse WSF6606W.
If you wish to discuss this further please feel free to contact me at [email protected] attention Leslie
Thanks,
Leslie

AFS

AFSasked

WSF6606W (White)

Do I need a qualified plumber to instal this machine?

1 answer
Johnno
Johnno

Hi. I always install my own dishwashers . There isn't too much to it, just need a little common sense and strong hand to connect the hoses. Probally a bit tricky for a lady so if you don't know anyone who can help you. I'd call a plumber for sure. Cheers John.

Amar

Amarasked

WSF6606W (White)

Am planning to buy this dishwasher for my kitchen, anyone has any ideas on any good deals around?

2 answers
Daveinthekitchen
Daveinthekitchen

winnings have a good deal on now

Amar
Amar

Bought this one from Harvey at good deal!

Huchiz

Huchizasked

WSF6606W (White)

How loud is 6606 when working? Is it quiet? Thanks guys.

1 answer
phantomm
phantomm

It is very quiet. The only noises I hear are when the pump sucks the water out, there is a gurgling noise, but very brief.

See all Westinghouse WSF6606 Series questions

Get an answer from our members and Westinghouse representatives

ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.