Spitwater Turbo 8-90 Boxjet Questions & Answers

Sorry, I’m just a user of the product & can’t answer that question. You should contact a Spitwater agent.

Thank you

Hi, I've not encountered that problem although I've had mine running for two to three hours some days. I dont know where you are, but we have a service agent in SA on Grand Junction Road. I'd take it to a service agent to get that issue sorted out.

Check oil level

Hi Trent, sorry, I'm no expert in repairs. If you are in SA, Spitwater on Grand junction Road do repairs & sell parts so you can DYI. The only time I've needed a repair they did it on the spot. I don't know who the agents are in other states. Google "Quiky 10/100" & you'll find the agents in each state. Hope this helps.

Hi Trent

Mt Turbo is 15 years old and I have never had to have it repaired, touch wood.
Take it to you local service agent.

Thanks Harry mine is also 15 years old, hope it's not an age thing

Sounds like a stuck bypass valve or blocked inlet filter. If you are in South Australia, Spitwater on Grand Junction Road will fix it in seconds. If you are not, either check that the pump is getting water thru the inlet filter or undo the nut below the pressure gauge and remove and clean/free up the valve inside. If that doesn't work, you may have to find a service centre.

1. make sure you have full mains pressure to the pump inlet
2. make sure the pressure regulator valve is turned up to full, rotate knob fully clockwise
3. make sure the spray nozzle on the end of the lance is in the out position . not pushed in position.
If not successful, see a service agent!

The pump is held on by four grub screws after you have removed them it slides apart. The pump has a male sharft with a keyway and may have coroded togeather so you mite need to prize them apart.