Read also:
sunshine blade instant heater ebay bauhn black series 55 review nyal cough cold and flu 5 star chef benchtop dishwasher aldi slim and trim results aldi portable air conditioner 2017
Mazda BT-50 Mk.2 (2011-2020) Questions & Answers
Also referred to as: Mazda BT-50 Mk.2 2019 and Mazda BT-50 Mk.2 2021. 4x4 3.2L Turbo-Diesel, 4x2202 questions from our users
Colt 45asked
Has anyone had any luck getting their DAB radio to work mine is rubbish works on accessory setting on the key all day, but once you turn the to on it drops all digital radio strength
Mazda won’t help me and the dealership here in Perth admits all BT50 alpine radios don’t have DAB radios that work!
No answers
Bryan L.asked
how do i get radio code for BT50 2.2 single cab 2015?
No answers
Bradley R.asked
Hey guys I have a 2013 Bt 50 and both my right side front and rear blinkers don’t work and I’ve checked the fuse it all seems to be okay there and I’ve checked the bulbs and that’s not the problem so I’m hoping someone on here could lead me in the right direction to what it may be thanks.
1 answer
I have the same problem and I am interested in finding the solution and the cause of the problem
Carollyn M.asked
Why is my BT50 recording conversations and replaying them 2or more years later?
1 answer
Never heard of this one. That poses privacy issues as they could listen to those when vehicle is in for service potentially. I'd be talking to someone about this maybe Fair Trading or Consumer Affairs.
Sassysue J.asked
What fuse does parkers come under?
No answers
Jodie S.asked
I can't get my radio to respond at all after a flat battery. Any ideas??
No answers
Ashley B.asked
I have a 2015 bt50 gsx. It has a traction control button at the bottom of the dash centre but doesn't to anything. Is it broken ? Or are you not a le to turn traction control off?
No answers
John Francis H.asked
Could anyone point me in the right direction on how to pull the dash out of a Mazda bt50 xtr 2011 model have coolant leaking from under dash
No answers
Jon M.asked
We serviced the bt50 and put a new oil and fuel filter in, started the car and then turned it off after about 30 seconds, now the car won’t start, any ideas
1 answer
No clue whatsovever other than I do know the procedure for an oil change is not as straight forward as most cars. If done incorrectly you can blow the engine.
Peter W.asked
How do you reset language on radio bt50
No answers
Shaneasked
I have a 2015 BT50 GT and the dash on the airbag has started to crack any one else with this problem
No answers
Cheryl K.asked
I have a 2WD Mazda BT50 Ute. When I go to indicate the indicators stay off. If I leave the indicator in the central position, the right indicator light stays on. As well as this, I have no left indicator light working at all. When I put the left indicator on, no indicator light goes on (right or left)
No answers
Greg H.asked
Cannot find problem with traction control light on solid, car takes off in 2nd/3rd gear, no cruise control, no kickdown or downshift when braking. Turn car off and it rectifies itself . Has been at mechanics for a few days and is doing there head in now reluctantly booked in at a dealer any ideas Cheers Greg
1 answer
Same here. They played with injectors and now doesn’t do it. But now the engine light is on.
Donna C.asked
Outside temperature gauge in dash is continuing to rise about 5 to 7 degrees above actual temperature.
Also idle speed is increasing at the same time.
Engine temperature gauge is fine no fluctuation
Any thoughts
No answers
Butterflyasked
Just bought a 2015 Mazda BT-50 there is a Ticking noise coming from dash - doesnt go away?
No answers
Stevoasked
Why is my 2013 Mazda BT-50 3.2 5cylinder have a loud ticking noise coming from the top of the engine
No answers
Mick M.asked
Hi, i have 2014 bt-50, & dont have brake lights, the fuse in drivers side compartment is fine; but works fine on boat trailer light board but still not on ute ? Cheers for any help
No answers
Mattasked
Our Powertrain light keeps coming on. No reduction in power. Manual so no dropping down gears.
Wondering if its Trans overheating maybe or faulty sensor?
No answers
Daniel K.asked
I have a Mazda bt50 my16. There is a loud ticking noise coming from inside the dash when the aircon is on. Doesnt matter if its on heating or cooling its still there. Does anyone know if this has been a fault with this model?? Is it an easy fix?
3 answers
I believe its the actuator that controls basically the *open/close* door and gears are stripped . Had the same issue. Was replaced in a day
Thanks Matt
2015 BT50 dual cab
Same problem. Left hand side vents flutuated in temperature. chilled then unchilled. Drivers side was fine.
Mazda service at Southport diagnosed tenuator problems.
1st 'fix' - disconnect battery for half hour. This resets 'setting'
2nd 'fix' - disconnect battery for more than half an hour.
Mazda replaced LHS tenuator at ~80000km. This also stopped the clicking/ticking noises from the the dash after vehicle shut down.
At 140000km the dash noises are back after engine shutdown
The left hand side does NOT chill. The RHS has started blowing chilled/unchilled and AC is struggling in the CQ heat
Noone to service it out here. It will have to wait til Christmas and back in Brisbane
Didn't have this with 2016 Ranger
Darrylasked
Took the BT50 2016 in for a service, AC was working fine but after the service it only seems to work about half cooling capacity. Dealer said they didn't touch the AC. Any ideas why an AC would suddenly work at half pace??? The passenger side seems to run cooler than the drivers side. Tried all combinations of climate control, MAX AC etc doesnt blow air colder than about 20 C
3 answers
take to Aircon specialist. Mazda service centres are not specialist. and I have found that they might not even have know they did anything ?
If they've disconnected or reset something, the front temperature sensor might be reading incorrectly. What does the temperature on the dash say? If it says something completely different to the outside temperature (like -39 Deg C) or not working at all, drive it for a while (about an hour) and you should notice the sensor will start heating up, the temp on the dash should start increasing (as it should) and the aircon should start working. If the temp sensors reading -40 (incorrectly), the aircon decides you don't need to cool when it's -40!
Thanks for that. Yes Im hoping that they accidentally reset something. I have an outside temp but no internal. I have to set it on max cool to get a bit of half decent AC. Do you know if an OBD tool can check on AC settings
ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.