501 questions from our users
Daniel S.asked
Hey there
I have a 2010 bt50 ute 2wd 2.5ltr turbo diesal
And all of a sudden the temp gauge goes up and down while I'm driving never goes past half way and I've done all the checks ie water,water pump etc engine is running perfect just the gauge keeps playing up anyone else experience this on there bt50
No answers
gregory h.asked
i have just brought a 2009 bt50 boss,has done 185000 had recon head, new radiator motor breathing heavy using oil.a catch can has been added, do you think its has over heated,and why is a catch can fitted.regards greg
No answers
ben p.asked
Can I do a engine swap 2009 bt into my 2011 bt
No answers
Shaneasked
I have a 2015 BT50 GT and the dash on the airbag has started to crack any one else with this problem
No answers
Mr.Gasked
Hi Guys I have a BT 50 2014 and it is in limp mode now, the reason for it to go into limp mode was water in the fuel, the take and all fuel lines have been removed cleaned and new diesel put in. there are no codes given out by diagnostics but I connected the diagnostics and cleared all again just in case. the BT still only revs up to 2000 rpm only? any takers?
3 answers
I am having similar issues with a 2016. Sporadic limping as I drive. Limped into the Mazda dealer and they hooked up their computer - said it was a pressure issue and not enough fuel was getting to the motor. I had wondered about fuel contamination but it did not make sense as it comes on sporadically when I was cruising rather than applying power. After reading your story I'm having second thoughts now as I want to limp back home about 150km away..... How did you get water in the fuel? Did you see it in the filter?
Yes sir, I noticed it in the fuel filter. The diesel was a milky color and that was how I know the there was water in the tank, removed the tank and opened it up, emptied it and cleaned it out. I used a few dry rages to get all the water droplets out. still went into limp mode after replaced with new diesel . I have done extensive reading and see no one knows exactly what causes it to do this. But I have solved the problem yesterday, I saw a clip on Youtube about the fuel temperature sensor and it, in room temperature, ( 40 degrees) should have a 2.5 to 2.8 ohm reading on a testing meter. mine was 0.213 ohms which means the computer was registering a temperature of about 144 degrees. it sits on the diesel pump and regulates the amount of fuel required as the warmer the fuel the the less dense it is and the computer will adjust the amount needed. like I said did a lot of reading. working fine now guys, hope this help anyone else. I have also made a note that every five thousand Kilometers, I will replace the fuel filter as I see we can not trust the filling stations any more to maintain their tanks.
sorry the water is always present in diesel, but that is why we have drain plugs on the filter housing. the filling stations are the ones that give water contamination as they dont maintain the tanks underground, water separates are normally on the pumps like you used o see in the old days, people just dont care anymore
paulasked
loud beeping alarm comes on when stopping, mainly at intersections. Stops beeping once I start accelerating
No answers
Brendan B.asked
Brilliant BT 50 but I’ve just bought an after market l light Bar to put on Do they have issues with the master control box went firing up I’ve heard that it might blow it can someone answer the question before I put it on thank you Brendan
No answers
Brendan B.asked
I have purchased a aftermarket light bar to fit onto the front of the car and I was wondering if anyone has had any problems with the main control Pane loverheating or do I have to go General light from Mazda
No answers
Vickiasked
Hi i have just got a bt 50 2016
When i trune the key off a lock it all up the power stays on to power socket it doesn't turn of and my navigation system stop on all night should it not cut off after a1hr
Thanks
Vicki
No answers
Jason . Basked
My passenger door will not activate my interior light but the drivers side door does please explain ??
No answers
Chris Stevensonasked
I have key stuck in the ignition.
parking light on dash is flashing.
any ideas what fuse to look at, or what to do 2016 bt50.
No answers
Ryan K.asked
Does the mazda bt 50 2011 glove box light stay on when lights are turned on??
Ryan K.asked
Gerald K.asked
I hv a BT50 and im stuck it cant start due to fuel flooding. What should i do?
No answers
Cheryl K.asked
I have a 2WD Mazda BT50 Ute. When I go to indicate the indicators stay off. If I leave the indicator in the central position, the right indicator light stays on. As well as this, I have no left indicator light working at all. When I put the left indicator on, no indicator light goes on (right or left)
No answers
Joshua M.asked
What does A and B I'm mean on dash, which one is accurate to how many k's I'm getting to a tank? And why are they different to each other?
No answers
Greg H.asked
Cannot find problem with traction control light on solid, car takes off in 2nd/3rd gear, no cruise control, no kickdown or downshift when braking. Turn car off and it rectifies itself . Has been at mechanics for a few days and is doing there head in now reluctantly booked in at a dealer any ideas Cheers Greg
1 answer
Same here. They played with injectors and now doesn’t do it. But now the engine light is on.
Rob'n Nicki K.asked
2014 manual .. Powertrain light has come on ?
No answers
Rob'n Nicki K.asked
2014 manual .. Powertrain light comes on occasionally and there seems to be a fan noise when changing gears??
No answers
ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.