Read also:
5 fin oil heater review ziegler and brown bbq review mothers choice celestial car seat review hoover heritage 5210 harvey norman miele complete c2 celebration vacuum cleaner review white knight laminate paint for benchtops dyson dc37c origin barrel vacuum reviewVulcan Freeloader 170L (648170) Questions & Answers
5 questions from our users
Garyasked
How long does it take for water to heat to max temp from cold on heat setting 5
Irish Kevasked
Pilot light on but no hot water.
I checked the relief valve and water coming out of pipe is hot.
No answers
Loraasked
I have a fairly new hot water system 170 litre vulcan freeloader on gas n it keeps on running out of hot water after 2 showers. Why?
3 answers
Take the bottom cover off and check what number it's set to. 3 will only barely give you two hot showers. Adjust to number 5 or 6 for winter and 3 for summer.
I was going to say the same, except I have mine between 2- 3 and I have plenty hot water and it`s the middle of winter, in the summer I have mine on 2. My thoughts are if your water is scalding hot you are wasting money because you then have to add cold water to use it, more money down the drain as they say.
1. Make sure you have a Water Saver Shower Head. It may be a simple matter of too much Hot Water flowing down the drain. 2. Make sure your Thermostat is not too High where the recovery is taking too long to reach the Temperature set-up. 3. Avoid having "Baths"on a daily basis. They use horrendous amount of Hot Water. 4. Stop family members from singing very long songs or Arias (Opera) in the Showers.
Richard Boudville 5th Oct 2018 Perth.
BJSasked
my sisters natural gas vulcan hot water storage unit keeps going out . should it be a thermostat problem? It is not leaking any water even though it is an old unit . I have an older unit on a farm working just fine .
1 answer
Hey BJS It could be the Thermocouple ( not sure about the spelling ) on my very first Vulcan I actually replaced this part twice over a 14 year period, I think it is something to do with the pilot light firing up. I hope this helps.
Pat
Ronasked
After having turned off the water supply for some other maintenance, then turned it back again, we get cold water service throughout the house but no water at all from the Vulcan hot water system, Is there an automatic water cut off in the system?
3 answers
Hi there. Make sure the water tap is fully open and check that the flame is on underneath by putting your head right down under the control knob. You can see the flame from underneath.
Thank you, all is well now. We discovered that the incoming supply of water to the unit had been cut, It has now been restored and the unit is back to good normal working order.
Thank you for your help.
As far as I know there is only one tap to turn the hot water off beside the unit, make sure your pilot light is lit.
ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.