- Sign in
- Write a review
Haier HWMP55-918 / HWMP65-918 / HWMP75-918 Questions & Answers
HWMP55-918 (5.5kg), HWMP65-918 (6.5kg), HWMP75-918 (7.5kg) (See All)125 questions from our users
what does e1 code and e3 codes mean
My Haier HWMP75-918 7.5kg machine won't drain unless the hose is at ground level. Could you help please?
Where do you put the fabric softener in this washing machine please
Machine does not stop filling up with water and floods the laundry
E2,what's the problem
Washing machine has had little use - water won't drain - HELP PLEASE.
My Haier Hwmp 65-198 once turn the power on. There is little funny noise. All the buttons on control board works fine. But when you press start the machine dose not start and there is no error message display. What could be the issue?
My Haier HWMP65-918 repeatedly says Er when on rinse and spin cycle when you lift and shut lid again it works for a bit then says Er again. When cycles finish the clothes are not spun & still very wet. What is the problem?
Where am I supposed to put the Fabric Softener in? There is no place for it??
Why there is a water leakage from underneath ? From only a year old machine ?
How do I spin only?
Hi
I have this model,and it is not washing it's only spinning and it makes a loud rattling sound at the end of the cycle.
Could you please give me some advice on how to fix this?
Machine will not drain technician said pump is good and that it needs a new drain hose for about $226 seems abit steep to me, if it's just the drain hose can I buy 1 and fit it myself thanks Dave
Machine will not remove delay.. there is no 0 or 1 delay. 2 is the lowest. It does not automatically remove delay when switched off
My washing machines bowl is not turning and I don't know why. Any help?
I have a problem with p65-918 .The spring holding the lid has popped out and when I went to put it back in I discovered the housing had cracked and broken away.is this a common fault with this machine?can any thing be done to re secure the lid as I have not misused the machine in anyway and feel that this shouldn't have happened.?
I have a problem with my machine p65-918 in that the spring in the lid has popped out due to the housing breaking away with out being forced in any way.Is this a common problem with this machine?is there any way it can be fixed?
Any ideas why my machine won't spin?
Or ways to get it spinning again
Is there a reset for this machine
Is there a reset button on this model
Get an answer from our members and Haier representatives
Other Top Loading Washing Machines
ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.