Read also:
ozito blower vac bag replacement betty bossi vegetable twister review kmart 3.2 litre air fryer how to clean fisher and paykel washing machine pump stegbar head office phone number sunbeam torino coffee machine review sunshine blade instant heater priceSsangYong Rexton Y200 II / Y285 II (2006-2012) Questions & Answers
SX, RX270 XVT SPR, RX270 Limited, etc...57 questions from our users
Gregasked
Hi. Appreciate your advice. My 2009 Rexton Diesel lacks fast excelleration power. It drives through the gears ok. Mechanic said that the DPF is blocked & a good run on the freeway for 39 min should fix the problem Well an hour later of freeway driving, the problem is still there. No too confident with my Mechanic as he lacks make/model experience. Your comments please. Regards Greg
No answers
Ian H.asked
2012 rexton lights for the air conditing mode display are very hard to see,how can they be made brighter
No answers
Pierre D.asked
What keeps the transfer box activated?
No answers
Kerryasked
In The last 5 years by SsangYong rexton has had it's fan belt either partially or fully wrapped up in the motor. last Friday week they just replaced my fan belt and also a couple of the small flywheels one was very flaky and the other was really rough on one edge I think they've replaced it with a smoother one. Is 1 meant to be really rough on the edge? And last Tuesday part of the fan belt was chewed up again. Do you have any solutions to this problem?thank you.
1 answer
I had similar issues, replaced belt and again within a week it shredded turned out to be the belt tensioner once this was replaced problem fixed you can get new one for about $350 fitted yourself or about double that if you have a mechanic do it.
kayasked
replaced brake pedal switch with ssanyong original part witch also cam with a short wiring harness to adapt to the updadet switch but now have no cruise control cant find any fuses have tryed disconect battrey to reset any thing and removing the memmory fuse wondering if it is not reciving signal from new brake pedal part
No answers
Oyvindasked
Hi, have ABS, EBD and ESP light that is comming on, when driving the car, also the speedometer jumps between 30 and 60kmt when driving in 60kmt when I push the brake pedal, they ale disappear, have also exspriens that I lose communication Whit the gear box when driving the car Whit this problems, just locked in one gear, any clue on what could bee the problem? also the engine lights come and goes, have had a computer on the car and it's said its injectors nr4 this is a 06 270xdi automat gear Car.
No answers
Brian Lasked
I've put new and correct front left door assembly in, but now it won't stay locked.
No answers
Stephenasked
Hi Everyone, I have a 2006 Rexton XDI 270 Auto. Which does not have traction control but as soon as I’m off road and it detects any loss of traction it starts to pulse and makes it harder to go through soft sand, is it the ABS system and is there a way to Delete?
Thanks Stephen.
No answers
Stephanie S.asked
Apologies for smart txt errors.
Hi David, three weeks ago in Jan 2022, I had top of range electric brake system installed in 2008 Rexton. (This car has been a nightmare btw). A few days after while towing the float, after aprox 100kms of no probs, the engine check light came on, she lost power and went into limp mode. Dangerous hwy at 3.30am, so I limped her 25ks to road house. After stopping there, topping up fuel, she started no probs and the engine check light was off. I took my time (slower) rest of journey. I drove her with float off when there (too see if related to new work) and she didn't seem to have any real kick back through boost? On the way home ECLight came on 4 times when under pressure up a hill & power loss again, so stop, it corrects, move on.
When looked at by electrics bloke it threw codes P1480 condenser fan & P0108 booster pressure sensor short. Advise if you have any please.
My lovely mechanic just retired, he at least had an idea on this vehicle and it's (issues).
No answers
Stephanie S.asked
Hi David, three weeks ago in Jan 2022, I had top of range electric brake system installed in 2008 Rexton. (This car has been a nightmare btw). A few days after while towing float, after aprox 100kms of no probs, the engine check light came on, she lost power and went limp mode. Dangerous hey 3.30am so I limped her 25ks to road house. After dropping there she started no probs and check light off, I took my time (slower) rest of journey. I drove her float off when the and she didn't seem to have any fear luck back. On way home ECLight on 4 times when under pressure up hill & power loss again, stop, corrects, move on.
When looked at by electrics bloke it threw codes P1480 condenser fan & P0108 booster pressure sensor short. Advise if you have any please.
No answers
Stephanie S.asked
Hi David, three weeks ago in Jan 2022, I had top of range electric brake system installed in 2008 Rexton. (This car has been a nightmare btw). A few days after while towing float, after aprox 100kms of no probs, the engine check light came on, she lost power and went limp mode. Dangerous hey 3.30am so I limped her 25ks to road house. After dropping there she started no probs and check light off, I took my time (slower) rest of journey. I drove her float off when the and she didn't seem to have any fear luck back. On way home ECLight on 4 times when under pressure up hill & power loss again, stop, corrects, move on.
When looked at by electrics bloke it threw codes P1480 condenser fan & P0108 booster pressure sensor short. Advise if you have any please.
No answers
Abendaasked
4wd check light on and the engine won't start
I have a rxston 2.7 2009 and i gat 4wd check light on and the engine won't start no sign of the key any idea?
tomasked
is the rexton a true four wheel drive?
No answers
Poeteerasked
I am picking up my 2008 Rexton 2.7 in the next couple of days. The seller has reported that it randomly goes into down hill assist mode. I think I can resolve the issue by removing the relay for the down hill assist. If you can advise on whether this will work please?
2 answers
Hi Mate
i see your post was a year ago but did that work and if so could you advise on where relay is located please
Hi Josie
I could not locate a sensor
When i read up in the manual that came with the car
It explained the fault that was experienced as a prompt to test the low range function.
I tested it by occasionally engaging low range and running through all gears in cluding reverse. I have since sold the car but the issue turned out not to be an issue. The previous seller was concerned that the locking in to hill assist may occur on the freeway. But it is designed to occur at start up.
Blue boyasked
Hi I have a Auto 2010 Rexton SPR 2-7 TD, I’ve done 134000 kms, seviced every 15000 kms, recently changed crank & cam sensors, i now have a high pitched, scream like noise when I’m accelerating, I been told it’s the turbo? Is there a cheaper fix?
2 answers
I assume that a reputable garage has told you that the turbo is failing ? Bearings in turbo can produce a high pitch noise.
If you are confident that the turbo is at fault then you can replace it either new or secondhand or have it rebuilt. Check with a reputable garage mechanic. Depending on what country you are in secondhand units could be located. Rgds David.
If the performance of the turbo is normal, it could be damaged air intake. Thos could cause a turbo whistle sound. The sound would be more audible as the revs get higher. Have a mechanic that is good with deisel check it before you buy anything
Puranasked
I have a Rexton II (2007). How to reset the time in it as time as automatically lapsed. Does it have a battery?
No answers
Dezi Wasked
I have a 2006 Ssangyong rexton 2.7 xdi, takes a bit to start it and the engine light comes on. When it starts it run perfect but Cruze control won’t work and after abit the engine light goes out and I can us the Cruze control again, then when I stop for awhile it is hard to start again and the engine light comes back on. Any suggestions?
1 answer
Hi the engine check light is an annoying light that often is initiated by the engine management system throwing up an error code due to a number of things. I would take it to any Repco or similar store and they will read the codes for you via computer... This will give a much better clue to the problem. I would guess it's due to an emissions issue. Get the codes read for about 50 dollars ? And then put your question back up on here or address it directly to me anytime.... Rgds David.
Paul Basked
I have just purchased a 2007 Rexton 2.7 manual. When driving it randomly beeps at me. The beeping is a slow high pitched beep that happens for about 5 to 10 seconds and then stops. It also does this in exactly the same manner when you first start the engine. There are no warning lights displaying and the way the car drives is completely unaffected. The car is obviously trying to tell me something but I have no idea what. Any ideas?
3 answers
I have a manual rexton 2.7 ...beeps can occur when the handbrake sensor left engaged or the car thinks it's still engaged due to a bad sensor. The other beeper is for the fuel water separator which normally lights up the dash light on the far left if the dash. Have you checked the fault codes that should show up a list of faults ...
No sorry I can't think of any think that could help you,,,, sorry Bob,,
Check your fuel filter. There is a water sensor at the bottom of it and yes, it can cause random beeps with no warning light if there is a tiny bit of water in it. Drain the fuel out of it and pump it full again with the hand primer. It should fix the problem (unless you have a lot of water in your fuel)
Jpwasked
I have a rexton 2009 270 SPR. THE HDC AND EPC LIGHTS ARE permanently on and gave been for sometime. I have tried deleting with a code reader.
Any ideas or do I have to go to the dealer?
2 answers
Hi,, Try disconnecting the Battery for about 3 or 4 minutes,,, then reconnect,,, it worked for my 2006 Reston,,
2006 2.7xdi Check crank sensor both ends and also electric cables behind the kick panels near the accelerator and passenger side as well .. had same problem including the airbag light resetting all the connections and cleaning them worked out for me... no more warning lights
deonasked
My 2008 2.7 diesel automatic ssangyong 4x4 light show low on the dashboard what can it be?
4 answers
Please be more specific with your question.
Accurately describe the problem and I can help you .
What lights are on ?
What gear are you in?
Have you selected 4wd low range ?
Regards
Once again I responded promptly to a question about a rexton.
I have done this previously and as usual this time once again I received no feedback from the originator of the question ...this is most frustrating, leading to think that I will not answer any more questions. Rgds David
I did not select any fwd gear I just switched on the ignition than the fwd low light come on .on the dash board
ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.