??!

6 questions from our users

Alf Mittelsmerz

Alf Mittelsmerzasked

PSR 18 LI-2

Does the PSR 18 LI-2 use the same or a compatible battery as the original PSR 18 LI?



1 answer
Alf Mittelsmerz
Alf Mittelsmerz

To answer my own question, yes it's compatible I find.

Uncle Wallie

Uncle Wallieasked

PSR 18 LI-2

Are the batteries still available for this drill?

1 answer
tassietony
tassietony

If you google the drill name and 'batteries' you will find them. You can still buy the drill.

Malc

Malcasked

PSR 18 LI-2

Selecting torque still slips when you reach 20 and can be stopped by your hand although you can tell the difference as you go up the scale! Any ideas. Malcolm



No answers
Robert H

Robert Hasked

PSR 18 LI-2

My psr 18 l1-2 will not operate with a full battery, tried the batteries in another psr. The lights on the drill come on and flash 3 times then go off. This drill has had very little use and has not been overloaded, any suggestions please?

1 answer
Jimbo
Jimbo

If this happens with both battery's, return it.
Dodgy unit.

Cody Coodle

Cody Coodleasked

PSR 18 LI-2

What is maximum speed of PSR 18LI-2?

1 answer
Ant12
Ant12

Max speed is 1340 rpm



Ronald

Ronaldasked

PSR 18 LI-2

The bright white light on the drill itself remains on and the drill doesn't function. What do I do? it is only 18mth old and hardly used.

1 answer
Ajay40
Ajay40

A battery can be virtually flat, yet the LED will still light up since it requires much less power to make the LED shine than it does to operate the drill. Make sure you've done a fresh charge on the battery. On my charger, the green LED flashes while charging and stays steady once fully charged. If you have a spare battery, do the same with it. You can get a bad battery, but if you can try two batteries, then the odds of this being the problem is probably pretty small. Otherwise the charger could be faulty. Keep an eye on when the green LED goes steady. It should take around 4-5hrs from memory.
One other thing, my drill's forward/reverse "button" has 3 settings i.e. forward, lock & reverse. The middle setting between the forward and reverse, locks the motor. I haven't tried, but while it's locked, you can probably press the trigger and the LED may even light up. Make sure that the drill is in either forward or reverse and try it again. Good luck with it.

See all Bosch PSR 14.4 LI-2 / 18 LI-2 / 18 LI questions

Get an answer from our members and Bosch Power Tools representatives

ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.