??!

125 questions from our users

Jack

Jackasked

Ranger PX.I (2011-2015)

Hello I’m thinking about buying a 2013 PX XLS ford ranger Ute with 145000 on the clock. Please tell me what experiences you have had with them and if it is worth buying.



No answers
Mike B.

Mike B.asked

Ranger PX.I (2011-2015)

hi have px1 2013 xlt, battery went flat and it went into limp mode, i replaced battery and all went well for 1 year, now flattened battery again and its going into limp mode. have abs, engine and traction light on. have a new battery and computer fault codes cleared, its throwing output speed shaft sensor error and ecm/pcm data invalid, some days its fine but others its in limp mode or ill be goojng 100km and it drops into first and revs out. have to put into neutral and turn off and sometimes it resets and im ok and some times its not. ford have said most probably new tranny $8000. Wondering if anyone has had this as there seems to be lots of occurrences like this. intrested to know if anyone can provide any light on this and how you can elliminate abs sensors

No answers
delphoto1

delphoto1asked

Ranger PX.I (2011-2015)

car is stuck out Bush help needed now

No answers
delphoto1

delphoto1asked

Ranger PX.I (2011-2015)

2014 xlt ranger
have lights on dash but wont start or shift auto into any gear

No answers
Solo L.

Solo L.asked

Ranger PX.I (2011-2015)

Hi I have a 2015 xlt ranger and having problems with my battery going flat over night. So I'm having to jump start every morning.only had Ute for tree months



No answers
Antony S.

Antony S.asked

Ranger PX.I (2011-2015)

My 2012 ford ranger traction control light keeps coming on and my engine but car has been serviced well all the the time and the car goes into limp mode this is a reoccurring does anyone know what to do to fix this

1 answer
Big Bri
Big Bri

Hi Antony, we have a similar problem with the company ute (2012 PX 2.2 litre). Did you find a fix for yours? Bri

Antony S.

Antony S.asked

Ranger PX.I (2011-2015)

My 2012 traction light and engine light keep coming on and the Ute itself has been losing power I just want to know what I can do so it this never happens again this problem always reoccurs and is annoying please thank you

1 answer
Big Bri
Big Bri

Hi Antony, we have a similar problem with the company ute (2012 PX 2.2 litre). Did you find a fix for yours? Bri



marc G.

marc G.asked

Ranger PX.I (2011-2015)

My 2013 2.2 limited started with a small misfire at low revs a few weeks ago. Not all the time,just every now and then. Then last week when I went to pull away it died and the powertrain light came on.i left it for 5 mins and then it started again. It's done this 3 times now and only when I put my foot down a bit. Could a faulty battery be doing this? Or something more sinister??

No answers
Carlo F.

Carlo F.asked

Ranger PX.I (2011-2015)

ihave a 2013 3.2 turbo diesel xlt ford ranger while driving the car stops running. No check engine light comes on . Pull over restart car and drive away. Happened 2 time this month

No answers
George K.

George K.asked

Ranger PX.I (2011-2015)

How do I get the gear shift out of a ford ranger low rider 2011 5speed petrol to check selectors

No answers
Ryan B.

Ryan B.asked

Ranger PX.I (2011-2015)

Hey I have 2013 hi rider ranger it only happens yesterday but it won’t move out of park (auto) why would this happen and what could i do to fix it ?

No answers
Mike

Mikeasked

Ranger PX.I (2011-2015)

Ford Ranger PX.1 2013 3.2/6
Also I'm struggling to find electrical fault in left/h front park light loom. Anything anyone else has found?

1 answer
MikeF
MikeF

If fitted with after market bumper with park lights then check little fuse box on +’ve battery terminal.

Mike

Mikeasked

Ranger PX.I (2011-2015)

Ford Ranger PX .1 2013 has the RH indicator light glowing on the dashboard at times. Usually when using cruse control. Any solution?

1 answer
MikeF
MikeF

I have same vehicle and a similar problem! My R/h indicator and vehicle imoblizer light on dash flashes when key inserted and in off position and these two lights glow when engine is running. They brighten when utilising cruise control.

Mike

Mikeasked

Ranger PX.I (2011-2015)

Ford Ranger PX .1 2013 has the RH indicator light glowing on the dashboard at times. Usually when using cruse control. Any solution?

No answers
Joseph Thompson

Joseph Thompsonasked

Ranger PX.I (2011-2015)

Hey all,
I got a 2014 px ranger and my car dosnt have any boost or speed like it’s so slow in all gear and it struggles to go fast like it’s so slow in 1 to 2 and I have to be in 5th gear to be doing 60 is that normal any ideas what might cause this?

1 answer
MikeF
MikeF

Run your hand under the boost hose going to the throttle body to check for a split! It usually splits under the hose down by the radiator where hot air is discharged from the radiator cooling fan. For a thorough inspection remove it all together to view properly. If it has split it is also time to replace water hose running to oil cooler (hose often rubs through under fuel filter mount. Add extra padding to new hose at fuel filter mount for longer life.)

NickB

NickBasked

Ranger PX.I (2011-2015)

Getting more frequent select drive won't engage first properly then engine light comes on turn car off restart select drive, no engine light drives perfectly, then some times you go to pull away eg set of lights after driving for a time it will slect first go for second but pick neutral then engine light comes on no gear selction turn of ignition restart back to nominal

No answers
Brettp

Brettpasked

Ranger PX.I (2011-2015)

Snapped fan belt got new one and new tensioner pulley now it’s snappped again when it’s cold ID drive off slow and the engine some where seems to be skipping but if I accelerate harder with more load it goes away

No answers
Sarel D.

Sarel D.asked

Ranger PX.I (2011-2015)

Good day i have 2013 ranger auto xlt 4x4, it only started last week when you drive it feels like the box surging between 1gear and 2 gear and 3 gear when goes 4th gear is seems to be okay, i would like advise before ford takes my arm and leg, it drives normal got power everything new motor was fitted by ford about 20000 km ago, can it maybe to do air mass sensor, adivse will be appreciate

regards
sarel

No answers
Cherie V.

Cherie V.asked

Ranger PX.I (2011-2015)

Px1 goes into limp mode eng light on all checks ok oil water air any ideas

No answers
Andrew

Andrewasked

Ranger PX.I (2011-2015)

Hi my 3.2 ranger has a rough idle that comes and goes. When it is idleing rough it stumbles between 1000 and 1500 RPM doesn’t matter what gear it’s in. There is no black or white smoke no fuel smells ist still got plenty of power. Iv replaced fuel filter air filter. Would it be a suction control valve issue. It’s got me stumped as it is an issue that comes and goes. can any one please help

No answers
Page 1 of 7
See all Ford Ranger questions

Get an answer from our members

Other Utes

Previous
Next

ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.