Read also:
pilot sport 3 vs re003 auspost load and go register aldi wall panel heater reviews item processed at facility sydney nsw kogan cordless water flosser review bosch highflow 17e pilot light 2 in 1 rechargeable hand/stick vacuum kmart reviewStihl MSA 160 C / MSA 160 C-BQ Questions & Answers
MSA 160 C-BQ, MSA 160 C4 questions from our users
peetoasked
what size chain do I look for to suit 160c
3 answers
usually it comes with a 12 inch bar. The chain for this is a 44 drive link, 3/8 low profile, 043 gauge chain. If you look near the long slot of the bar you will see stamped into the bar these measurements.
I have a battery stihl chainsaw which leaks oil from the port that puts oil on the chain. Done it from new and sent it back only to be told “that’s what they do”. A great little saw but their weak excuse means I will not buy another stihl product.
Arch
The chain is not a 3/8 low profile, it's a 1/4". The only Stihl battery chainsaw that has a 3/8 low profile chain is the newly released MSA 220 C-B.
Valerie Jonesasked
Why is my Stihl leaking oil?
1 answer
Hi Valerie, Denis here, I have this Model Chainsaw and could not be happier with its performance. There are 2 locations where oil comes from, one being the oil reservoir to supply oil for the chain, this has a cap that is sealed with an "o" ring and this may need replacing or get a replacement cap, not expensive. The other oil that you maybe getting is oil build up off the chain and this is normal, if storing or carrying in vehicle just place a absorbent cloth under the saw. Hope this helps.
Bevanasked
with a MSA160-BQ and a AP300 Li-ion battery pro 36V227W H and the AL300 rapid charger will a 650 watt inverter sufficient to operate the charger to charge the battery. Reason for this is I have this size inverter in my caravan.
Thanks
1 answer
Hi Bevan, I have the same battery charger and it requires 290 watts input to run charger, however to actually start the charger it requires considerable more wattage, I have a Redarc pure sine wave 350 watt charger and it will not charge the AL 300 Battery. If your charger is a pure sine wave charger it may be enough to get that initial start up required. I had to revert to my 2KV generator to charge the battery. Sorry I cannot be specific on just what size Inverter is required. I would put the charger on your inverter, place the battery in the charger and test, if the green light comes on and stays on and the Battery lights are flashing, that is the number that require charging you are in business. Hope this helps. Cheers
Michael1asked
Can I purchase on line
ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.