??!

6 questions from our users

ant

antasked

DFN38450X (Stainless Steel)

just run my Beko for first time on program 8 30 minutes it gets down to 1 minute and stays there until I override it to make it stop. Any ideas?



1 answer
Ozzie85
Ozzie85

Be been told the programming does not take into account the fill times, the heating of the water or the drying time. This makes the program seems like it runs longer and stalls at the 1 min mark. If left alone, the cycle should finish when completed.

Sue

Sueasked

DFN38450X (Stainless Steel)

Our dishwasher is very loud. Does anyone have the same problem or can give me suggestions on what to do to reduce the noise? Also, is it possible to turn off the 3 beeps which occur at the end of the cycle as this can also be loud in the middle of the night?

1 answer
Eve
Eve

I use P3 cycle, no probs with sound, very quiet. Try it, if still noisy then call Beko servicing, they will assist you. Am assuming it's still under warranty?

Delilah

Delilahasked

DFN38450X (Stainless Steel)

We purchased this Beko dishwasher in February. Base on the advice in a previous review we've been using Programe 6 & running the cycle overnight. When opening the door the next morning to unload we are finding the items inside are still wet; like heat condensation droplets. We thought the dry function would prevent this! Has anyone else experienced the same issue & can you offer any suggestions? Thanks in advance.



4 answers
Bev
Bev

Yes you leave the door ajar slightly you are getting condensation Hope this helps

Nina 61
Nina 61

I usually use program 3 and don't have this issue.

Delilah
Delilah

Thank you Bev & Nina 61; I will try both of your suggestions :)

Janette

Janetteasked

DFN38450X (Stainless Steel)

Does the top come of and if yes what height would it be please i need it to be 8250mm or lower.



1 answer
Nina 61
Nina 61

We were told the top could come off and it looks like it would. Without the top it would measure 8200.

Ken

Kenasked

DFN38450X (Stainless Steel)

Hi
Could any one please advice me about tbe two White Plastic threaded stand, are they required to be fitted ? I have installed without these and found later inside however it seems stable ?
Thanks for the help in advance

2 answers
Quint
Quint

you only need to use the white threaded stands to allow you to level dishwasher if it rocks or sits uneven. You do not have to use if it sits level and with out movement. Quint.

Ken
Ken

Thanks

Cazza

Cazzaasked

DFN38450X (Stainless Steel)

Is this dishwasher quiet

1 answer
snapback
snapback

It is not as quiet as my beloved Kleenmaid that it replaced, but, yes, it is very quiet. However, I cannot compare it to other brands, as I have not experienced them.

Get an answer from our members and Beko representatives

ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.