Read also:
yates weed and feed reviews sunbeam torino coffee machine review westinghouse virtuoso fridge not cooling britax platinum pro sict review nyal cold and flu fighterFisher & Paykel DD60DCW7 Questions & Answers
6 questions from our users
Krissyasked
Is the handle a seperate strip or is it a full top piece (panel) required to repair
DD60DCW7
No answers
Krissyasked
Is the handle a seperate strip or is it a full top piece (panel) required to repair
DD60DCW7
No answers
Robert Paullasked
How do I replace a control display unit. Mine is faulty and unreadable.
2 answers
Have a look on YouTube as I recently replaced the handle
Wonderful.
Thank you Joanne. Merry Christmas, Robert.
bennersasked
used on normal cycle stops quickly 2 beeps can open drawer but does not restart .ok on other cycles
Cause?
Richardasked
My DD60DCW7 bottom dish drawer has broken handle. I have a replacement but don't know how to fit it. Can anyone help?
Thanks,
Richard.
3 answers
Turn machine off at the wall. You will need long nose pliers. There are two plugs on either side of the dishwasher drawer. Twist and pull those out. The entire front panel will pop off leaving the handle. You should then slide the handle to the left (the entire control panel is a part of the handle. Once its slid off, unplug the display screen from the main part of the dishwasher - taking note of how it plugs in.
You can removed the the display screen from the handle by popping it out with your fingers or gently with a flat head screw driver. If you didn't receive buttons when you bought your handle you will need to be carefull not to break the exsisting ones
Transfer the display to your new handle. repeat steps in reverse. Connect wires to main part where you disconnected them for earlier, slide handle on (left to right), pop the front piece back on and put two plugs back into side of dishwasher.
If you google replacing dishdrawer handle there is quite a lot of videos showing you how to do this,
Hope this helps :-)
Thanks Sahri. I looked at google and found plenty of videos but non on replacing handles, so I bit the bullet and followed your instructions. Worked perfectly!
Dismantling was very easy. Re-assembly was also easy, a little difficult replacing the front panel but eventually got it fixed.
Thanks again Sahri.
I've had the same issue. Thanks Richard for the original post and Sahri for the solution to the problem. Tried your advice Sahri with good results. The front panel was bit difficult to re-assemble but with a little persistence it slotted into the handle again.
eireneasked
I have just bought the new two drawer f&p dishwasher with the controls for both drawers on the outside of the top drawer. I have not worked out how to use it with both drawers washing at the same time. This is possible isn't it?
Please help!
5 answers
I have the exact same one! Haha
You can control both draws whenever you want independent of eachother.
Press the draw button to switch between draws you want to control. (They will get highlighted as u switch. If you highlight the top draw and press stop it ill dyop thr top draw and bottom will keep going.
James :)
James
Your answer doesn't make sense to me.
I want to make both drawers work at the same time.
Can you explain again please
I bought mine yesterday and was told that both drawers can operate independently, and it says the same in the instructions. By way of the word "can" being there as opposed to the word can being absent, it is virtually stating that both drawers operate simultaneously but the machine has the added feature of them being able to operate one at a time. It would seem however, they cannot operate simultaneously, which is a real pain. If this is the case I feel like I have been ripped off. Hopefully I am wrong and it is just a matter of the instructions being incomplete. I would also like an explanation.
ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.