??!

9 questions from our users

Shagufa3000

Shagufa3000asked

HR6TFF437SD (Stainless)

Can you please tell me where the drain hole is ? I need to check it as my fridge is leaking water inside . Thank you



4 answers
Hisense
Jasmine F.Hisense

Hi, If you give our friendly technical support team a call on 1800 447 367, they will be able to address your enquiry.

Janie
Janie

You have to completely defrost the fridge. I have pulled mine apart. Only way is to transfer to another fridge. It is now my beer fridge, ouside as it leaked all over my solid wood floors

Shagufa3000
Shagufa3000

Oh that’s no good, it leaks a bit inside on the first panel .. will see what happens and what to do, thank you

Sam

Samasked

HR6TFF437SD (Stainless)

What is correct temperature settings for Hisense HR6TFF437SD?



2 answers
Samina Munshi
Samina Munshi

We set it according how we stuff it. If it's really packed, then we turn near to coldest. Normally, when we have few things in there, we set it at intermediate level. But never at low.
Hope it helps.

Sabina
Sabina

Fridge 18

teena dillon

teena dillonasked

HR6TFF437SD (Stainless)

Hi just asking if I have cleaned my stainless steel fridge HR6TFF437SD with gumption and now I have marked the fridge or it looks like some of the paint is removed do you have suggestions on how to restore it?

1 answer
Tommo
Tommo

Hi Teena, I am not sure of the damage that gumption would cause or how to fix the damage it has caused as I haven't used gumption on my fridge, I have used it on other fridges with good results but not on my current fridge, sorry i couldn't be more helpful. Kind Regards; Tommo



qldshark

qldsharkasked

HR6TFF437SD (Stainless)

Where is the drain hole on model Hr6tff436s?

4 answers
Daniel S
Daniel S

It is under the evaporator unit in the freezer behind the plastic panel.

qldshark
qldshark

Have taken screws out but panel won’t come out

Daniel S
Daniel S

Here is the trick. The styrofoam is also attached to the plastic panel. You have to pry the panel down from the corners, lift up the bottom corner and pull the assembly all out from the four corners. Took me a while too but eventually they both came off. The Fan is attached to the plastic panel and the styrofoam goes around it. You need to get them both off. I had the same issue. The plastic panel will not come out easily unless the styrofoam is also removed. You run the risk of breaking the clip down the bottom ( middle ) of the plastic panel otherwise. Email me and I will send you photos as I took them for in case someone would ask.

Martin

Martinasked

HR6TFF437SD (Stainless)

What is the plastic thing with holes in it for I've had my fridge for going on 5 years it's been a great fridge no problems at all.

2 answers
Corinne
Corinne

Heya is it the egg tray? It’s removable flat with shallow sides. And loads of holes to balance eggs.

Deb M.
Deb M.

I just got this fridge and I have that too. The six big hole thingy? I also don't know if there's supposed to be actual tray with these egg holders. Or is that it and they don't clip or fit nicely anywhere?

ROULI

ROULIasked

HR6TFF437SD (Stainless)

Hi just wandering if anyone has a problem with the fan on hisense iv had mine for 3 years the freezer is cold but fridge isnt getting cold plz help

1 answer
Sandeep C
Sandeep C

Even I am facing same issue.

Matty

Mattyasked

HR6TFF437SD (Stainless)

Hi can anyone tell me if this model has a drain hole it has been leaking water the seals are ok on the fridge if it does where is it located?

No answers
Julez

Julezasked

HR6TFF437SD (Stainless)

Is this model frost free?

1 answer
Mandy page
Mandy page

I believe it is best to google it for sure. If its starting to ice up then do a serious defrost like ive suggested to others

Hitch

Hitchasked

HR6TFF437SD (Stainless)

6 mnths old & up till now its been great!, but, the freezer door has started to open by itself. Lucky so far as Ive found it early enough each time to prevent defrost or thaw. Any ideas on why or how to rectify?

1 answer
jeremy.ieraci
jeremy.ieraci

A freezer door opening by itself, you surely have at least one poltergeist. Contact your nearest paranormal team immediately!

But if this is not the case: freezer seals are dirty, or dislodged in sections. Clean and refit. Angle is not slightly tilted back to prevent this and/or close automatically. You're welcome.

See all Hisense 436L Top Mount questions

Get an answer from our members and Hisense representatives

ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.