??!

23 questions from our users

Corco

Corcoasked

CFX 95DZW (94.5L)

Hi guys, we have a brand new cfx95dzw, it ran beautifully on 240 but now we plugged it into the ute on 12v and now the freezer is going up in temp not down it was -16 now it is +1, just wondering if anybody has a suggestion of what it might be that's wrong?



2 answers
Mal
Mal

Change the cig lighter plug for an anderson

shannond100
shannond100

Possibly the same problem as mine. Get it looked at before warranty runs out. Compressor control board plays up

Junaid

Junaidasked

CFX 95DZW (94.5L)

I have a CFX 95 dzw,I run it off the 12v output in the back of my Ute,every time I turn the car off and then restart, it turns the wifi to off on the control panel and then I have to turn it back on again.Is there anyway it can remain on so I don’t have to always manually activate it after stopping?

1 answer
Mal
Mal

The cause of this is because you are using the factory cig plug accessory socket in the car. When you start the car there will be a few seconds of no power to the fridge and it will reset.



To prevent this from happening you need to run the fridge directly to a powered source preferably either a battery pack like an ARK Pak or an aux battery. The cig lighter socket does also not draw enough current for the fridge especially in hotter conditions.

If running directly to a start battery, even though the fridge does have low voltage cut out I would recommend an automatic isolator be installed to ensure you dont have a flat batter in the car also keep in mind standard batteries will not last long with constant current draw as they are not designed to be cycled like that

Gavin D

Gavin Dasked

CFX 95DZW (94.5L)

i have a cfx95 and just wondering if i am traveling and stop at a park can i leave my 12v supply plug in while i plug it into 240v power?

1 answer
wolffram
wolffram

Hi, yes you can. All Waeco fridges have a 240v override, so they will automatically run on 240v when it is available without the need to unplug the 12v cable. Just a tip - I always switch my fridge off before disconnecting the 240v supply, then turn it back on once you have unplugged. This is kinder to the compressor motor, as you are not interrupting its power supply. (No need to do this when connecting to 240v, just when disconnecting from 240v).



Page 2 of 2
See all Dometic Waeco CFX Series questions

Get an answer from our members

ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.