Dishlex DSF6106X (Stainless Steel) Questions & Answers

Hey Linda, how'd you go with this? I've got the same problem :(

We would also like to know this, for the same reason...Last night my partner loosened a side panel and squeezed his hand in there to remove the old hose but now I have to get another hose as the one I bought has a fitting too large for this machine. I thought they were all they same.

Sorry I can't offer any constructive ideas.
Sounds like what my one did. the service guys said it was the mother board in the electronics and part with labour
would be close to new price. Against my principles it went to the tip to be replaced by another brand.
This seems to be a too common occurrence which I have expressed to Electrolux who import dishlex dishwashers

Very unusual if making a noise when switched off. I would first check that the filter and large filter plate in the bottom of the dishwasher are seated correctly. If this is not the problem, pull the dishwasher out from under the bench and run it again in that position, which may allow you to get closer to the noise and identify the culprit. If then there is no noise it could have been either of the hoses or electrical connection cable resonating against something. Hope these suggestions may help.

Thank you John E it turns out it is the fridge now I still need to find out why

Hi George.
Dishlex is part of the Electrolux Group and manufactured in Australia until 5 years ago. Electrolux manufacture in Europe, USA, and China and one report said Dishlex was made in Europe. Their basic instructions are printed in 32 languages so there you have it. Robt3.

The dishlex dishwashers are manufactured in Poland

call service .
This is the fault code and without experience and documents you will not repair this fault

Did you get a plumber to install it if you did call them if not I would get one to come out to see what your problem is don’t try to fix yourself due to warranty let a professional look at it and they will tell you if it’s faulty

This is the fault code and without experience and documents you will not repair this fault

Hi Shah, I was googling same question tonight. The anti flood button activated when we had a blocked drain. I reset it following this advice; https://www.justanswer.com/australia-whitegoods/6n0ua-fix-anti-flood-device.html

Did you leave it finish the cycle? I found out myself, that, if I open it before finishes the cycle, the next load won't start. I turn it on and leave it to complete the previous cycle and Then it is ready to be set on for the next cycle. I hope I was a bit helpful to your answer.

This is the fault code and without experience and documents you will not repair this fault

Hi, I changed to a different cycle, changed my dishwashing tablets and most importantly kept the filter clean. I also deferred to a dishwasher repair person to check it out. I’m not an expert just a consumer who tried a few things out themselves. If you’re not sure calla repair person. NB: I’m just a consumer

try cleaning the spray arms,
it is normal for dishwashers to leave water at the bottom
try powders and different tablets as well. I recommend Fairy or Aldi.

Yes it should. There are a couple of brackets with screws under the top. Take these screws out and then slide the top to remove it.

Have you tried looking at the water taps underneath your sink? There could be a tap / water flow stopper connected that is stopping the water from coming through if it’s brand new? Check other places that water would enter the dishwasher as it may be blocked somehow. Also, check if it’s under warranty still and call dishex.

I'm having the same problem. I totally emptied the bottom of basin water and it restarted, then Stopped after it filled again. Happened yesterday.