??!

498 questions from our users

Willem K.

Willem K.asked

Ranger PK (2009-2011)

Hi All, My ford starting was great and then started losing power when I go up hill and when I accelerate it will just cut power. It di it twice in 85kmns and then 8 hours later on my way back it did it everytime I accelerate to above 2000rpm. I changed the oil filter and it was very dirty but now after putting it back I can only start the car then it idles fine and when I press the pedal to rev it just bogs down an die or goes up from 1.500 rpm to about 2000/2500 and then come down again or if I keep holding the pedal down it dies or stalls the engin.



I hope this makes sence please help?.

No answers
Ian M.

Ian M.asked

Ranger

I am looking to buy a 2014 2.2 dual cab ranger. 220000 km. Is 14000 a fair price and any issues I should look out for? Thanks

No answers
John

Johnasked

Ranger PX.II / PX.III (2015-2020)

What month was the PXII first sold in 2015?
I’m trying to work out if I have a PXI or PXII

I have a build date of Sept 2015, compliance date 10/15 & a vin ending in FW500493



Confused

2 answers
Mark P.
Mark P.

Old or new front end? Old px1 new px2

John
John

Thanks Mark. New I think? - What is the main difference in the front end, appearance, I assume you mean?

Carlo F.

Carlo F.asked

Ranger PX.I (2011-2015)

ihave a 2013 3.2 turbo diesel xlt ford ranger while driving the car stops running. No check engine light comes on . Pull over restart car and drive away. Happened 2 time this month



No answers
Luke

Lukeasked

Ranger

Hey guys my coolant is low could I just top it up with water? As o don't have coolant currently?

No answers
George K.

George K.asked

Ranger PX.I (2011-2015)

How do I get the gear shift out of a ford ranger low rider 2011 5speed petrol to check selectors

No answers
Jonathan M.

Jonathan M.asked

Ranger PX.II / PX.III (2015-2020)

Has anyone else had an issue with the engine coolant over temp alarm going off? Gauge on dash constantly moving always under temp never over.
2017 3.2l xl spacecab.
Coolant level is fine, sensor has been replaced (alarm went off straight away), pulled thermostat out Which stopped alarm for a week but has now started again! It’s driving me nuts as it beeps at me every 200-1000m at times.
One thing I have noticed is the noise from aircon under passenger dash has picked up. And I have used 4wd a few times we just aren’t sure if it was before alarm started. We’ve scanned it and no major codes come up. Any help would be greatly appreciated as the fuel economy has gone out the window because it’s always reading cold engine

1 answer
Moses P.
Moses P.

Hi. I just brought a ranger 2013 xlt wellside 4x4. Looking for items for this year of model I'm confused when items for 2012-2014 models then has x1 or 2x2 etc. Can anyone tell me if my one comes under any of the pxs. Regards.

Ryan B.

Ryan B.asked

Ranger PX.I (2011-2015)

Hey I have 2013 hi rider ranger it only happens yesterday but it won’t move out of park (auto) why would this happen and what could i do to fix it ?

No answers
Mike

Mikeasked

Ranger PX.I (2011-2015)

Ford Ranger PX.1 2013 3.2/6
Also I'm struggling to find electrical fault in left/h front park light loom. Anything anyone else has found?

1 answer
MikeF
MikeF

If fitted with after market bumper with park lights then check little fuse box on +’ve battery terminal.

Mike

Mikeasked

Ranger PX.I (2011-2015)

Ford Ranger PX .1 2013 has the RH indicator light glowing on the dashboard at times. Usually when using cruse control. Any solution?

1 answer
MikeF
MikeF

I have same vehicle and a similar problem! My R/h indicator and vehicle imoblizer light on dash flashes when key inserted and in off position and these two lights glow when engine is running. They brighten when utilising cruise control.

Mike

Mikeasked

Ranger PX.I (2011-2015)

Ford Ranger PX .1 2013 has the RH indicator light glowing on the dashboard at times. Usually when using cruse control. Any solution?

No answers
Patrick D.

Patrick D.asked

Ranger PK (2009-2011)

Where is the thermostat on a 2009 Ford Ranger

No answers
Joseph Thompson

Joseph Thompsonasked

Ranger PX.I (2011-2015)

Hey all,
I got a 2014 px ranger and my car dosnt have any boost or speed like it’s so slow in all gear and it struggles to go fast like it’s so slow in 1 to 2 and I have to be in 5th gear to be doing 60 is that normal any ideas what might cause this?

1 answer
MikeF
MikeF

Run your hand under the boost hose going to the throttle body to check for a split! It usually splits under the hose down by the radiator where hot air is discharged from the radiator cooling fan. For a thorough inspection remove it all together to view properly. If it has split it is also time to replace water hose running to oil cooler (hose often rubs through under fuel filter mount. Add extra padding to new hose at fuel filter mount for longer life.)

NickB

NickBasked

Ranger PX.I (2011-2015)

Getting more frequent select drive won't engage first properly then engine light comes on turn car off restart select drive, no engine light drives perfectly, then some times you go to pull away eg set of lights after driving for a time it will slect first go for second but pick neutral then engine light comes on no gear selction turn of ignition restart back to nominal

No answers
brett

brettasked

Ranger

I’m about to upgrade my ranger and I’m looking at the 2 lt biturbo model
Question I have is in regard to towing with this engine
My 2015 px11 xlt 3.2 tow fantastic and has been great

1 answer
Peter
Peter

The Vehicle is Fantastic for towing, absolutely no complaints there...

Adam

Adamasked

Ranger PX.II / PX.III (2015-2020)

hi everyone,i have 2022 px.III wildtrak.i bought 14 months ago got 28k on the clock.recently i have seen puddle of clear hot water leak underneath the car when i use the heater.pressure checked and serviced everything seems normal they said (ford service) anyone having same problem as mine with their ranger?did’t have this water leak in 14 months and started happening a week ago.

1 answer
dimakatso m.
dimakatso m.

I have a similar problem

Boeta

Boetaasked

Ranger PK (2009-2011)

Where do I get the starter relay (location)?

No answers
Brettp

Brettpasked

Ranger PX.I (2011-2015)

Snapped fan belt got new one and new tensioner pulley now it’s snappped again when it’s cold ID drive off slow and the engine some where seems to be skipping but if I accelerate harder with more load it goes away

No answers
Barry B.

Barry B.asked

Ranger PK (2009-2011)

I can only get 4th gear only

No answers
Karan

Karanasked

Ranger

Greetings, I have the ford 2011 ranger wildtrak and the 4x4 is not working, im trying to find the correct number 4x4 motor but cant find....051910 45-54-648-004-B can anyone help in finding this? I live in south America.

No answers
Page 2 of 25

Get an answer from our members

Other Utes

Previous
Next

ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.