Read also:
50 up club click energy bauhn 55 inch 4k tv aldi stirling portable air conditioner safe n sound unity capsule compatible prams euro chef air fryer review bosch pcm 1800 sd review bellini 3 in 1 air fryer super sleeper pro mattress topperHaier HDW13G1X / HDW13G1W Questions & Answers
HDW13G1X (Silver), HDW13G1W (White)10 questions from our users
Tom E.asked
How do you operate machine
1 answer
It's (The Buttons) very sensitive, move your fingers over the power button once, if that doesn't work do it again.
How to change your settings check the manual..... Like I said the buttons are very sensitive so just move your finger over the button to get your settings right.... Again check your manual :)
Stay Safe
I hope I've been some help :)
Simon M.asked
what does e 30 mean
2 answers
That error code means there is an issue with the drainage pump or over flow sensor and there is still liquid in the bottom of the dishwasher. Please fund the info that I have sauced from the Haier service support centre for technicians
Code:E30
Description:Overflow Alarm
Cause:
1.The drain pump does not work
2.Water is in the bottom tray
3.The overflow switch failure
4.The connecting failure
5.The overflow switch is assembled on incorrect position
6.The mainboard failure
Simple Solution:
1.Replace the mainboard
2.Check the leakage position and then reassembly it or replace the leakage component and record the leakage reason
3.Replace the overflow switch
4.Reconnect the harness
5.Reassemble the overflow switch
6.Replace the mainboard
These are not full steps you have to take but more guide lines for service techs that come to your house to do repairs.
If you still have warranty, call Haier and they will send a fisher and paykel service tech to your house
Hope this helps.
thank you
Simon M.asked
what does e 30 mean
No answers
Jeffasked
What is the E40 fault and why is water leaking from the door.
1 answer
Water leaking from the door would indicate that there is an issue with the door seal. This could be from a damaged seal to even something being in the way of the seal and allowing water to escape. I have looked up codes for this model as I have one and I was curious but there is nothing within the manual. A very long call to Fisher and Paykel are also known Haier as they seem to have one staff member working their call centres for Australia and New Zealand. The result was a flow meter error which also could be why water is leaking out the door. This error could cause the unit to overfill.
If you haven't in the past, clean the spray arms, filter and mesh bottom. The run a heavy wash with a finish Dishwasher cleaner and run the unit. This issue could result from a Control panel error to sensor error and if it is just the sensor, I hope there is just some grease built up and the cleaner hopefully will clean it away. This is in no way a fix if there is an issue but just what I would do before replacing or getting the unit repaired.
Furthermore, I recommend doing the finish clean once a month with normal use or more often with heavy use. I also recommend not using short cycles and either using Auto or heavy cycles.
Dave T.asked
how to reset the time shown on this dishwasher.
1 answer
You keep your finger on the power button untill it starts moving to were you need it to be. If that doesn't work press the button below it the same way... Sorry I took a few days to reply :) Hoped it helped...
Dave T.asked
How to reset the time showing on this dishwasher.
No answers
Dave T.asked
how do you reset the time on the above
1 answer
Time meaning a clock? That particular model doesn't have a clock. It does have a count down timer though which to cancel a cycle and start a new one you can pause the cycle, turn it off for 10 seconds and the power back up. This will allow you to select a new program from scratch.
If you want to cancel a delay timer you can press the delay timer until its restarts back to 0 or follow the steps above.
Michaelasked
Should the door click shut when not in use?
Kenasked
How do I remove E30 off my dishwasher?
No answers
Jackie Wasked
How to use it. Surely each cycle does not take 2 1/2 hours
1 answer
There are different cycles. There is a fast wash option that takes 30 mins. Press the next button which is the left bottom button that is just an arrow until the second option from the right is lit. It looks like a little cyclone. This will show 30 mins on the screen. For reference the info is also written on the top of the front door..
ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.