Read also:
aldi 40 inch tv review australia post load and go check balance eucryl tooth powder chemist warehouse jumbuck 57cm black charcoal kettle bbq why does dun and bradstreet keep calling fisher & paykel wh7560j2 review
Kubota ZG124E Questions & Answers
7 questions from our users
Felix.Aasked
Does the Z122R catcher fit the ZG124E mower as I am looking at buying one that was never used.
No answers
Felix.Aasked
Does the Z122R catcher fit the ZG124E mower as I am looking at buying one that was never used.
No answers
Paul W.asked
The PTO on my machine stops working at odd times, when it stops, I shut the machine down, turning everything off for a couple of minutes it will run again, maybe all day maybe 2 minutes, any clues?
No answers
freddieasked
Mower was working good, suddenly stopped working . We have checked fuse all seems OK . Can you surgest what my be wrong with it .
Boomerasked
I have replaced pto switch, seat switch. I did this because it wouldn’t even click when I turned the key. I jumped the pto with a wire and it fired right up and ran the whole time I cut. Next time nothing again so with the jumper wire still on pto switch I put a jumper on seat ran great yet again. Today after replacing both switches it fired up and as soon as I engaged the pto it died and won’t even crank. What’s going on with this mower. It’s a ZG124E. Briggs and Stratton engine
1 answer
G'day Boomer.
Electrics can be a pain, especially an intermittent fault. You appear to be fairly Savvy & nearly on top of things. Problem could be anything from the Ignition, PTO, Park Brake, to the Motion Control Switches, or simply a loose connection or fuse, even a poor battery terminal connection. (some may only require a slight adjustment). Any one will affect Start/Run/Cut. Your dealer or Mr Google will have a wiring diagram. Switches do not like moisture.
Best to get a cheap multimeter & follow the "Lockout Switch Trail" in your Operators manual, to save yourself replacing expensive switches.
I have solved similar problems by CAREFULLY running a hot wire from the battery to temporarily bypass one switch at a time, starting at the Starter Solenoid, with the mower on blocks & working my way back to the battery.
Chances are that as the problem is still there, your PTO & seat switch might have been working O.K. These can be tested with a multimeter or a small load, eg, a 12 volt lamp.
A small lamp bridging an installed faulty switch should light up as power should be available up-steam & load down-stream.
I am still getting used to having everything in the right position at the right time. My old mowers had no Lockouts or just a single Deck switch.
Hope this helps. Cheers. Trev.
Geneasked
ZG 124e hit a stump machine will run but mower won't engage, any help?
1 answer
The drive belt can jump of the clutch assy under mower near rear wheels and can sit above the clutch assy which needs a close look as it looks as if it is on the pulley if this is the case get a small bar and lever the belt tension arm towards the left hand rear wheel which will give you a chance to put the belt back on the pulley (be careful as it is spring loaded) this happened to me when I ran over a tree branch if not it may be the wires to the drive clutch pulled off. Hope this helps
Regards Allan
Other Ride-On Mowers
Razorback All Terrain
4.5(32)AS-Motor AS 940 Sherpa 4WD
4.9(15)Rover Mini Rider
4.1(22)Cub Cadet RZT S Series
4.3(10)Kubota Z200 Series
4.1(10)Masport Crossjet
3.6(10)Hustler Raptor
4.7(9)Jonsered YT Series
3.8(4)ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.