Westinghouse WSF6608X (Stainless) Questions & Answers

Hi, I cant speak for powder as I use a tablet and I never have any issues with that, I suggest you may need it looked at by a technician, not sure if its still under warranty. with drying my favourite setting is the heavy option and the timeframe isn't long at all for this option.
maybe worth trying a tablet, make sure you have full rinse aid and use heavy, then let me know if that helps, otherwise you may need to get it looked at.

I have a new WSF6608 dishwasher and after a few successful cycles it is also now failing to open the powder/tablet flap in use. Sounds like a service call might be in order also. I have tried with the tablet button selected and not with no difference. I think this is only for the 2 in 1 type of tablet, so you wouldn't think it would make a difference.

I have a new WSF6608 dishwasher and after a few successful cycles it is also now failing to open the powder/tablet flap in use. Sounds like a service call might be in order also. I have tried with the tablet button selected and not with no difference. I think this is only for the 2 in 1 type of tablet, so you wouldn't think it would make a difference.

I am actually having the exact same issue and came here looking to see if anyone else was having a similar problem. I would love to see what the answer is to this.

My machine is less than 4 months old and has been doing this on and off for the last couple months and is starting to get really annoying!!

Try the tablet setting... I haven't noticed a problem when I remember to turn it on.

Mine did this 3 days ago! Its 2 years old, there are NO blockages anywhere but still won't drain! Following this thread.

Mine has just done this today - exactly the same as you have both described. Did you find a solution? Mine is under 2 years old - about 18mths

I've this same problem. Did you get an answer?

Yes - I contacted Westinghouse, and after sending them photo's of the dishwasher, they sent out a technician with the correct basket for model I had.

Turkey

Same here, we bought smaller plates .

Just raise the upper basket as shown in the manual, and your dinner plates should fit, I did this and it worked for me.

I have the same problem, the upper basket is raised and I still have trouble with plates, they are a standard size plate, 25cm or 10 inches from side to side.. is there an alternate upper basket that can be fitted that is not so deep..

Peel off the protective film

Sorry - I need more info. When does it flash? Where does it flash? Next to a menu selection? What buttons have you pressed, in which sequence before this happens? If any? I haven't watched it through any cycles to know if this is normal, sorry.
Is it malfunctioning, or does it wash as normal?

I would call the manufacturer if it’s still under warranty. Mine has never done that so not sure. Sorry

H02 means the delay start function has been activated. Press and hold the Start/Pause button for 3 seconds to cancel it.

Hi Darren, have a look at the manual, however I wouldn't think it would be an issue, however I'm not a technician.

What did you end up doing? My manual states cold water connection only.

According to the manual "A water tempering valve is required if the water temperature is over 60°C." So if your water temperature is below that, it should be fine. In general running with hot water will save some money (as the dishwasher doesn't have to heat the water) but the dishes may not be quite as clean (as sometimes the hot water will effectively bake some food onto plates). There can be issues with ensuring the hoses can support hot water, and the differing pressure, but as the manual seems to indicate it's fine with hot water - you should be fine.

Yes, mine's the same... annoying, but worth it for a good washer - I just lift it before I push it back in.

Hi Tania, I've sent you an email, hopefully we can sort this out

Plates and glasses need to be replaced if they hit the washer arm. Or buy a new dishwasher which can have variable shelf. Its a choice. its best to buy a single plate of many sizes, then see how they stack. Return any plates that are too big, or bowls that are awkward and don't seat right in the trays. Its a pain i know. But at least you will fit a full 12 place set in the dishwasher at one time.

I had he same issue but discovered the top drawer (that holds the cups) is adjustable (blue and grey tabs on the side of the drawer) and can be adjusted up to create more space for the bottom drawer to hold dinner plates

Hi there!
Only just got this question from you sorry if the answer is too late. I don't absolutely know for the washer as I don't think we had a problem but you could try using a hair dryer blowing on hot to loosen the stick on the sticker as this will warm the glue and the you should find it comes off with ease, be gentle when pulling and you don't have to make it red hot just warm enough to unpeel then any residue remove with nail varnish remover or a bit of wd 40 on a cloth. We do this on all products with sticky stickers and it works well for us. Please be reminded you do this at your own risk but it does work.
Good luck!
theuglidog