??!

6 questions from our users

doris

dorisasked

Dedica EC680R (Red)

machine has been working fine but just recently only releases coffee for 2-3 seconds then stops also works the same when coffee holder removed only short amount of water comes out at normal flow, any help?



2 answers
Kat
Kat

I would guess that you need to reset the machine to run the shots longer. You can find the instruction manual here and it has instructions on how to reset the shot length https://www.delonghi.com/Global/InstructionManuals/EN/EN-Dedica-Pump-Espresso-EC680-im.pdf

doris
doris

Thank's Kat for replying, but I eventually found the problem by removing the coffee filter /strainer cup (which looked perfectly clean) placed it into a steel container with a heap table spoon of Bicarbonate soda mixed with water enough to well cover filter height and place filter in UPSIDE DOWN and bring to the boil for about 5 min, you will then see the water going brown as the tiny holes in the filter clearing. then give it a try and see the difference. This method should be in the instruction book.
Regards,
Joe.

Wagner

Wagnerasked

Dedica EC680R (Red)

What does it mean when the yellow light is constantly flashing on steam button when processing coffee? Have descaled a couple of times?

1 answer
Mkljmca
Mkljmca

Had the same issue. I resolved it by accessing the temp settings menu and setting the temp to medium.



Marc

Marcasked

Dedica EC680R (Red)

The Frot button of my machine (De Longhi Dédicace) remains always blinking and orange. What can I do to solve this problem? Can I still use the machine to brew a coffe? Thanks!
Marc boucher, Montreal (Quebec)

3 answers
Jim H
Jim H

Most likely it needs to be de scaled. Check out the manual and you will find instructions

AARON C
AARON C

Have a look on youtube there is a sequence that needs to be followed. Specifically the end of the de-scale. Needs to be shutdown correctly or the de-scale light will continue

CJK
CJK

https://www.youtube.com/watch?v=qSftBIW-MzM



Bingo

Bingoasked

Dedica EC680R (Red)

The machine stops too soon. Not enough coffe made. Is there any way to adjust. ? Thanks

1 answer
AARON C
AARON C

Press the button again. Or if you want a "flat white coffee" place under the milk frother (dont press the froth button) just turn the froth handle and it will provide hot water

heywebster

heywebsterasked

Dedica EC680R (Red)

My power button is stuck. Only under a month into using it. Any DIY advise apart from sending the machine back?

1 answer
rba
rba

Send it back to the retailer. Or, leave it switched on all the time - it only uses a microscopic amount of power once it goes into sleep mode; just press one of the three buttons to wake it up. You can program how long before it goes to sleep - 9min/30min/3 hours from memory. Obviously you'd switch it off at the mains if you are leaving it for weeks.

Bron

Bronasked

Dedica EC680R (Red)

I have descaled the machine the orange light is blinking and wont stop. Any ideas?

2 answers
Elle Chua
Elle Chua

Hello, I had the same problem and I descaled the machine twice. I finally found the best fix and solution. See the link:

https://www.youtube.com/watch?v=qSftBIW-MzM
Why your delonghi dedica 680 won't finish descaling in less than 1 minute

Bron
Bron

GENIUS Thank you that is brilliant it worked my machine is back to normal ⛧⛧⛧⛧⛧

See all DeLonghi Dedica questions

Get an answer from our members and DeLonghi representatives

ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.