Read also:
bob jane t mart brookvale aldi 32 inch tv review portable air conditioner target australia woolworths comprehensive car insurance review how much is the bambillo massage bed roachkill cockroach gel bait reviewFisher & Paykel FabricSmart Top Loader Questions & Answers
IW812, WA1068P1 (10kg), WA8560P1 (8.5kg), etc...115 questions from our users
Tex M.asked
Fault code 11101010 please help
No answers
Jim P.asked
Hi can you tell me the flow rate of the discharge pump on this washing machine. Litres per minute.
Thanks
No answers
Midnightasked
My wa80t65gw1 92133a spins out but clothes are still soaked. P ump is working and no blockages evident. No water left in bowl. Any help?
No answers
Chrisasked
No power to top panel. All power sources checked. Could it be a controller board?
No answers
Chrisasked
No power to top panel. All power sources check out ok.
No answers
Dougasked
Dimensions
No answers
rosscoasked
we are experiancing issues with serious lack of softness in towels. after much trial and error we are no closer
No answers
rosscoasked
we are experiancing problems with the lack of softness of towels. we have tried almost everything to achieve softer towels, all to no avail. please advise us of any 'tricks'
No answers
Neuroasked
where is the temp up button on IW712?
No answers
Annie Zonasked
I have a fabricsmart machine and the filtration isnt working. There is fluff on everything in every wash
No answers
Tonyasked
How to resize after installing a new motor controller
No answers
K Bandaraasked
it is unbalance. when I watch a online video It says this is caused by blocking the holes on drum. I opened in as shown on video. It shows balancing rod but my machine has not go a one like that. Drum holes were clear.
Can you provide the manual to check whether this machine has no balancing rod or it was missing from manufacturing.
No answers
Nancy Heyesasked
What is the point of the glass lid? I thought I would be able to see through it!
No answers
Jo W.asked
My machine fills up, very slowly because we have low water pressure. I open the lid and watch the level of water covering the clothes. Then the lid locks, it does some kind of surge sound, and when I can open up the lid again it seems to have emptied itself and the detergent and then it starts again. After 10-12 minutes into the cycle, it then starts washing. It doesn't matter if I choose auto fill or not, or Eco wash? Also it is very noisy clonking sound as it is detecting the water level.
No answers
Jodie L.asked
WA80T65FW1 fault code 50 fix
No answers
Renayeasked
My fabric smart WA80T65FW1 keeps saying off balance on spin cycle no matter how much is in the machine and I have to adjust it several times before it will continue and finish. How do I fix this?
No answers
Shane S.asked
No answers
Vinceasked
What is fault code 37
No answers
Kayeasked
Hi My Machine has stopped going, I did a wash this morning and it went thru no problem and now has no Power, checked the switch which is live ....? what might be the problem, It is 7 years old.
Thank you
No answers
Shannon C.asked
A message come up fault code 37 was does that mean can anyone help please
No answers
ieatwords.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ieatwords.com.au may earn commissions for products/services purchased via affiliate links.